The Heat Transfer Kit (1 – 1 room) is designed to transfer air from one room to up to one room. The kit consists of an intake vent, one outlet vents and everything in between you will need to set up a successful air transfer system. This can work very well and is very energy efficient, as the system utilizes heat that would otherwise be wasted in heating an already hot room. It also uses some of the warm air that would just accumulate near the ceiling. The system uses very little power, about 10 times less than an electric heater. This is important for energy conservation, low running costs and for people who generate their own electricity.
1 x TT Mixflow 150 Inline Fan with Speed Switch and Power Cord – EXVUTT150RV
2 x 6m High Quality Insulated duct R1.0 Rated – EDI01506M10
2 x 150mm Plastic Cone Vent – EVVUC150
1 x Duct tape – EATAPED
1 x Hanging tape – EATAPEH
1 X Thermostat (Optional Accessory)
Capacity: 520/405 m3/hr
Max Power used: 60 Watts
Noise: 44/33 dBA
Weight: 3.3 kg
IP rating: IPX4
2 Year Replacement (conditions apply).
About the Thermostat (If selected)
The thermostat does not use batteries.
It is usually placed in the same room as the heater so it will turn on the fan once that room is warm and the extra heat can be taken to other rooms. Once the temperature drops, because too much heat has been taken or the heater has been turned off, the thermostat will turn off the fan.
Note: Electrician Required
**Fan & components must be installed by Qualified Persons unless a lead & plug is installed in which case the fan can be DIY installed**